After a long period of use, concrete mixers will suffer from various minor problems, causing some new owners to be confused. Today, Xiao Bian shares a common problem in the use of concrete mixers. The relevant concrete mixers are turning at large throttles. The reason why the tank shakes when it is jarred.
The reason why the concrete mixer truck shakes when the throttle is large is mainly caused by the following reasons:
For one reason, there is residual concrete on the inner wall of the can body, especially at the end of the head and the feed cone at the rear, due to gravity eccentricity.
Second reason, the raceway surface is uneven, with bumps and dips, every time when the tank body is combined with the surface of the roller, it shakes once and shakes once.
The reason is as follows: 3. The surface of the supporting roller is uneven and has a high point. The number of jitters is the same as the number of rotations of the supporting roller for each rotation of the tank.
Cause four: The internal gear transmission of the reducer is not stable, and the front of the vehicle feels more jittery.
Cause 5: There are air inside the hydraulic system, which may cause the hydraulic pump to empty, the motor to make empty work, or no power. Vehicle shake is more obvious in heavy vehicles.
Cause six: There is a problem with the coaxiality of the can body itself, there is an eccentricity, and the heavy load of the vehicle is more obvious.
To sum up, the six kinds of causes that caused the concrete mixer truck to shake at the time of a large accelerator turn were the cause of the severe car shake. If the investigation is conducted one by one according to the above reasons, this problem can be solved.
The barbed wire is twisted and braided by a fully automated barbed wire machine. Commonly known as tribulus terrestris, barbed wire, and barbed thread among the people. Finished product types: single-filament twisted and double-filament twisted.
Raw materials: high-quality low-carbon steel wire.
Surface treatment process: electro-galvanized, hot-dip galvanized, plastic-coated, spray-coated. There are blue, green, yellow and other colors.
The reason for surface treatment is to enhance the anti-corrosion strength and prolong the service life. As the name suggests, the surface treatment of galvanized barbed wire is galvanized, which can be electro-galvanized or hot-dip galvanized; the surface treatment of PVC barbed wire is PVC-coated, and the barbed wire inside is black wire, electroplated wire and hot-dip galvanized wire.
Uses: Used for the isolation and protection of grassland borders, railways, and highways.
Barbed Wire,Anti-Climb Blade Barbed Wire,Galvanized Security Fencing Barbed Wire,Hot Dipped Galvanized Barbed Wire
Anping County Dongjie Wiremesh Products Co., Ltd. , https://www.dongjiewiremesh.com