1. Appearance check: Check the appearance of the sensor to be inspected. If it is found that the appearance of the sensor is cracked, the sensor may be damaged.
2. Rough inspection of the line: The power supply line, signal line and shielded line of the sensor are coaxial cables, which can be tested with a multimeter (ie, power line - signal line, power line - shielded line, signal line - shielded line). If a short circuit, disconnection, or a drop in insulation performance indicates that the sensor may be damaged.
3. Measure internal resistance: When there is no dedicated detection device, the input impedance ZI and output impedance ZO of the sensor can be measured with the ohm file of the digital multimeter, and the measured value and the nominal value of the product certificate provided by the manufacturer For comparison, when the measured value exceeds the allowable range, it indicates that the sensor may be damaged (Note: The self-numerical value of the multimeter to be used should be accurate, and it is better to use after measurement verification/calibration).
4. No-load detection:
Remove all sensors and access measurement circuits one by one. Under no-load (no-load) conditions, a well-performing sensor will quickly return to zero and the displayed value will be more stable, while the damaged sensor may show a digital jump. Can not return to zero and other phenomena. After the manual clearing the above phenomenon will still be repeated. Connect all sensors, still carry out no-load measurement, remove a sensor and observe whether the displayed value can be stable, then the sensor After it is still connected, the other sensor is removed and measured. All sensors are measured in sequence. If it is found that the value returned to normal after a sensor is removed, the sensor may be damaged.
5. Load check: When the above method cannot be used to determine the damaged sensor, load calibration can be performed on all sensors using the standard calibration method. The load test is performed on the sensors one by one using the standard weight of 1t. The undamaged sensor shows the measured value as the superimposed value of the standard weight gradually loaded, and the measured value displayed by the damaged sensor will have a large deviation from the superimposed value of the standard weight gradually loaded. .
CHANGZHOU SULI DRYING EQUIPMENT CO.,LTD.specializing in the production of Mixing Dryer, Spray Dryer, Granulation Dryer, Crushing Dryer, Efficient High Speed Mixing Granulator and V-shaped Mixer.
Sale services
Our experienced technicians is available on the phone also the internet, clients can get instance guidance by telephone, email, online service anytime, anywhere.
After-sale services
Normally, the equipment warranty is 12 months since installation. To establish long term cooperation, we will regularly call and email our clients, to check the equipment working condition, offer suggestions for maintenance.
Product introduction:
Screw mixing working principle is adopted for YMMX series of large-capacity Vertical Mixer. Firstly, feed the material into the hopper, then the screw conveys the material to the top of the barrel, and the material drops as umbrella-shaped and keep mixing to mix material well.
Functions of YMMX series of large-capacity vertical mixer: automatic working timing, overloading protecting, alarm for feeding limit.
Applications:
Grain products of plastic, crushed material, flakes of plastic, new and old mixed plastic material. pigment adding and mixing.
Horizontal Ribbon Mixer,Double Conical Mixer,Slot Shape Mixer,Vertical Mixer
Changzhou Su Li drying equipment Co., Ltd. , http://www.sldrying.com