There are many kinds of feeders, and common types in our industrial production are air feeders, roller feeders, three-in-one feeders, and so on. Today Xiao Bian gave you an analysis of some of the problems with these three common feeders:
First, how to install the air feeder?
Installation of air feeders must ensure that there is an independent source of air, because the air feeder is powered by air, so the stable air source is an important guarantee for the stability of the feeding accuracy, the air source must be stable, if the air source is unstable, it will Causes inaccurate feeding, thus affecting the stamping product quality.
The first air feeders are standard landing frames, solenoid valves and gas tanks to ensure the stability and accuracy of feeding. In the feeding process, the gas source consumes a lot. If there is no gas supply for the gas tank, the supply of the subsequent gas source can easily be insufficient, thereby affecting the feeding accuracy.
The second kind of air feeder, the air source consumes less, the air source of the general factory can supply very steadily, so the feeder is not equipped with the air tank.
Second, how to distinguish the quality of roller feeder?
First, look at the feeder gear before backing it up. Gear grinding quality, feeding machine, poor quality gear hobbing machine. The price of both gears can be one time.
Second, observe the feed roller heat treatment hrc600 hard chromium plating and polishing and plating, so high hardness, good wear resistance, long life.
Third, the appearance of the roller feeder can be observed to see if the paint is bright, the feeder is of poor quality, and unwilling to spend money on the paint. Also see if the machine is smooth surface, feeder. The quality of the feeder with good casing grinding quality is poor, and it must be directly sprayed with the ordinary grinding machine.
Three, three in one feeder material introduction:
The components of the three-in-one feeder are mainly gears, straightening rollers, feed rollers, leveling parts, bearings, material arcs, spindles for the material holder, and copper linings. These components are installed in accordance with high standards, are in line with the actual standards of bar and raw materials in the lathe conveyor, their common reasonable combination to improve the quality of automatic lathe feeder.
The Conical Johnson Screen is a kind of tubal Johnson screen which has a wide upper part and a narrow lower part.
It is composed of support rods and V-profile wire rolling welded on the special welding machine. We can adopt different material to suit your work condition. The common material are 304, 321, 316 L, 904 L, duplex steel 2205, duplex steel 2207, Monel. etc
Conical Johnson Screen
Wedge Wire Screen,Conical Johnson Screen,Stainless Steel Conical Johnson Screen,Conical Wedge Wire Johnson Screen
Xinxiang Shengda Filtration Technique Co., Ltd. , http://www.shengdafiltration.com