Adjustable Light Steel Roll Forming Machine for Auto Cutting and Punching

A.Main technical parameter
1, Raw Material : hot-dip galvanization steel strip
2, The thickness of the raw material: 0.5-1.8mm
3, The width of the feed-in: 400mm
4, The inner diameter of the steel coil : 508-600mm
5, The outer diameter of the steel coil : 1200MM
6, Main forming machine motor:Electromagnetic speed motor 7.5kw
7, Working voltage 380v 50hz  control voltage 24v
8, Forming steps: 12steps 
9, Main forming machine use welded steel structure 
10, Transmission mode : gear wheel transmission( the material of the gear wheel use 45# steel, the surface disposed by high frequency )
11, Roller shaft use 45# steel, modulation disposal, the hardness of the modulation is  HB250-280.surface grinding. The outer diameter is 60mm
12, Roller mould use Gcr15,salt bath quenching.hardness is HRC58-62
13, The fastest production speed 0-22M/ minute
14, Tolerance:  +/-0.50mm
15, Feed-in material way : from left to right 
B .cutting equipment 
16, hydraulic pressure qua power switch off
17, The ability of the cutting: 6tons
18, Hydraulic system pressure: 12Mpa. Work pressure 5Mpa
19, The form of the cutting: 45 degree skew
20, cutting scrap: no
21, The cutting machine frame use the high structural frame welding
22, The cutting mould is mould steel CR12, salt quenching hardness  is HRC60-62 
23, Cutting length tolerance <= 1.5mm 
24, Steel structure frame 
25, Max bear weight of machine is 2tons
C.The whole production line 
Feed-in machine --- material right/left guide --- correct calm machine - molding mainframe - roll mould ---finished product correct straight machine --- hydraulic prssure cutting equipment( hydraulic pressure station) ----- track cutting stepped vehicle - sever mould ---- received frame of material --- electric control box  
D.Meas of the machine:
Main electric  L 5000mm X W 1650mm X H 1250mm
Length of the production line L 14500mm×W 1650mm X H 1250mm
The volume of production L 20000mm X W 4000mm 



 

Aluminum Briquette Machine

Aluminum scrap metal, in the form of turnings, filings, chips and shavings, is produced every day of production, piling up on the equipment and floor. While aluminum and fluids waste can be costly to dispose of and difficult to reuse without processing, aluminum briquetting allows manufacturers to both eliminate costs and create a new revenue. If your chips are small, then can directly pressed by briquetter, if long, better press after shred.

Aluminum Briquetter, Aluminum Shavings Briquette Machine, Aluminum Chips Briquette Machine, Aluminum Press, Aluminium Briquette Machine

Jiangyin Metallurgy Hydraulic Machinery Factory , https://www.jiangyinyejing.com