1, traffic congestion caused by equipment leakage
Insufficient reason: affecting the centrifugal pump discharge more straw gas leakage, bottom valve leakage; water inlet blockage; bottom valve into the water to try; centrifugal pump speed is too low; seal ring or impeller wear too large; suction height exceeds the standard.
Treatment method: check the suction pipe and the bottom valve, the plug leakage gas source; clean the water inlet of the sludge or plug; the depth of the bottom valve must be greater than 1.5 times the diameter of the inlet pipe, increase the depth of the bottom valve into the water; check the power supply voltage, increase The speed of the centrifugal pump, replace the seal ring or impeller; reduce the installation position of the centrifugal pump, or replace the high lift pump.
Like this situation is the lack of traffic in the centrifugal pump idling. The two filters are directly connected. The first is the filter bag filter, the second stage is the filter cotton core type, and the two matched filter pumps are the same as the power 2.2 kW (3 hp) centrifugal pump. When the filter from the filter of the syrup pump 1 is filtered to 2 filters, the flow rate will be reduced, so the medicinal agent is not enough. 2 Centrifugal pump in the filter, after working for a while, no. The slurry pump will be insufficient due to the flow of no water idling, which was caused by pump damage last fall.
There are two solutions to this situation.
First: No. 2 in the filter centrifugal pump open work, not only from no connection, the liquid is filtered directly. The barrel filter in 1 to 2.
Second: Yes, the two filters directly enter the double-tower filter, and the filter bag filter barrel uses a cotton-core filter barrel with a centrifugal pump.
2, start the centrifugal pump not filled with water, the slurry pump runs
Centrifugal pumps can not be filled with water, be sure to check the centrifugal pump that is filled with water before the centrifugal pump is pumped, and the centrifugal pump will be damaged by water.
3, the shredded card reduces efficiency in the impeller
If the card is stuck in the impeller, it will cause vibration and noise of the centrifugal pump, reduce the working efficiency, and reduce the flow that causes the pump to be damaged due to the idling of the centrifugal pump. Keep awake debris and keep the centrifugal pump running smoothly.
Fischer-Tropsch wax can be used in plastic processing, such as injection molding, extrusion and pelletizing industries. In the production process of masterbatch and modified plastics, Fischer-Tropsch wax contributes to the dispersion of fillers and excellent smoothness during mixing. It can be used as an external lubricant for PVC. The low viscosity can increase the production speed of the product. It helps to disperse the pigments and fillers during mixing. It is especially useful in the extrusion of high-viscosity systems. It is more than ordinary PE WAX. 40-50% less, and can significantly improve the surface gloss of the product. When using intense colors, the melted Fischer-Tropsch wax can effectively wet the dye and reduce the extrusion viscosity.
When used in the ink as a particulate powder, it can improve the wear resistance and wrinkle resistance of the applied material. When applied to the coating, it can have a wrinkling effect, and when used in a micro powder state, it can form a wrinkle effect of stripes and water lines. When powder coating resin is added, it plays a role of lubrication in the extrusion process, which can reduce screw torque, reduce energy consumption and improve production efficiency.
Fischer Tropsch Wax,Fischer Tropsch Wax,Tropsh Wax,Fischer
Henan Shunbang Chemical Industry CO.,Ltd , https://www.suspensionpvc.com