The inspection cycle should be determined according to the actual conditions of the equipment.
The minor repair cycle is conducted every half month to one month and includes:
(1) Check the bowl tile;
(2) Check the wear of the taper sleeve and the straight sleeve and check the gap.
(3) Check the meshing clearance of the bevel gear;
(4) Check the transmission bushing clearance;
(5) Check the hydraulic device (if the hydraulic device is not equipped) and the lubricating device or replace the lubricating oil;
(6) Cleaning of main parts.
The medium repair period is about 4 to 6 months, and its main contents include:
(1) Replace the liner;
(2) repair or replace the eccentric bushing, taper sleeve and straight sleeve;
(3) repair or replace the bowl tile and dustproof device;
(4) Repair or replace the bevel gear, drive shaft and bearing bush;
(5) repairing the adjustment ring and the support sleeve thread;
(6) Carry out all inspections and treatments of minor repair projects;
(7) Decompose the motor, blow dust and descaling and check the bearing bushing of each part; decompose the oil switch, clean and deal with the defects; electrical adjustment and test of each part; check and repair the switchboard and other cable lines.
The overhaul is about four years or based on actual conditions. Its contents include:
(1) repair or replace the rack and the basic part of the problem;
(2) Carry out all inspections and treatments of the intermediate repair project, as well as carry out technical transformation;
(3) Replace the stator coil of the motor (determined according to the preventive test) and dip the paint; determine whether to replace the rotor shaft according to the actual situation.Hydraulic Busbar Cutting Punching Bending Machine
The multifunction busbar processing maching is the patented product developed by our company.Comparing with the traditional Busbar Processing Machine, this product has the following advantages and features:
The punching and shearing units adopt round integral structure, with novel and unique design rendering reasonable force bearing, and thus effectively guarantees the long-term use without deformation;
The bending unit uses integral structure and CNC angle control mode, allowing easy operation and high accuracy;
This machine adopts the design approach of double-layer work bench, truly realizing the simultaneous working of three stations without mutual interference;
The machine is provided with an automatic oil charge and discharge system, easy to operate, with the hydraulic oil charged into the oil tank via a filter so as to protect the entire hydraulic system from contamination;
This machine is provided with stainless steel oil tank to protect the hydraulic oil from corrosive deterioration, and extend the service life of hydraulic oil and the seals; PLC control that is stable and reliable.
Swappable dies offering extreme convenience;
PLC control that is stable and reliable.
Hydraulic Punching Machine,Hydraulic Busbar Cutting Punching Bending Machine,Cnc Busbar Punch Machine,Cnc Busbar Shear Machine
JINAN EURO-ASIA MACHINERY CO., LTD , https://www.eaelectricmachine.com